6.11 Error Identification

With each turn report you will receive a list of all the orders that were input. After this is a list of error reports, which detail any mistakes that occurred during the turn.

The error codes are printed at the bottom of the sheet that lists the orders inputted, and they are listed as follows --x y z--, where x, y and z are:

x - The section of the turn sheet the error occurred in

y - The order number where the error occurred

z - The error itself (see 10. Error Codes, p114)

Example:--4 2 13--

4 - Section 4 on the turn sheet - "Set up Additional Battalions"

2 - The error was in Order Number 2

13 - Error number 13 - "Not enough EcPts to carry out the order."

In the printout of the orders entered the following symbols will be replaced :

'.' will appear to separate the numbers in each order.

'0' will sometimes appear instead of 'A' or 'E'

The error codes are explained in the appendix, 10.1, 10.2, 10.3, etc.

Previous Topic:6.10.5 Demolishing Production Sites

Next Topic:7 Land Battles